Tagasi

ISO 248-1:2021

Rubber, raw — Determination of volatile-matter content — Part 1: Hot-mill method and oven method

Üldinfo
Kehtiv alates 30.06.2021
Tegevusala (ICS grupid)
83.040.10 Lateks ja toorkummi
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
30.06.2021
Põhitekst
10.10.2011
Põhitekst
This document specifies two methods for the determination of volatile-matter content in raw rubbers by using a hot mill or an oven. These methods are applicable to the determination of the volatile-matter content in the “R” group of rubbers listed in ISO 1629. These are rubbers having an unsaturated carbon chain, for example natural rubber and synthetic rubbers derived at least partly from di-olefins. These methods can also be applicable to other raw rubbers, but in these cases it is necessary to demonstrate that the change in mass is due solely to loss of actual volatile matter and not to rubber degradation. The hot-mill method is not applicable to natural rubber, to synthetic rubbers which are too difficult to handle on a hot mill or to synthetic rubbers in powder or chip form. The two methods do not necessarily give identical results. Therefore, in the case of dispute, the oven method, procedure A, is the reference method. NOTE       The applicability of each test method to various types of rubber is summarized in Annex A.
*
*
*
PDF
64,44 € koos KM-ga
Paber
64,44 € koos KM-ga
Standardi monitooring