Tagasi

ISO 3251:2019

Paints, varnishes and plastics -- Determination of non-volatile-matter content

Üldinfo
Kehtiv alates 14.05.2019
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
14.05.2019
Põhitekst
31.01.2008
Põhitekst
This document specifies a method for determining the non-volatile-matter content by mass of paints, varnishes, binders for paints and varnishes, polymer dispersions and condensation resins such as phenolic resins (resols, novolak solutions etc.). The method is also applicable to formulated dispersions containing fillers, pigments and other auxiliaries (e.g. thickeners, film-forming agents). NOTE 1 The non-volatile-matter content of a product is not an absolute quantity but depends upon the temperature and period of heating used for the determination. Consequently, when using this method, only relative and not true values for non-volatile-matter content are obtained owing to solvent retention, thermal decomposition and evaporation of low molecular mass constituents. The method is therefore primarily intended for testing different batches of the same type of product. NOTE 2 This method is suitable for synthetic rubber lattices, provided heating for a specific period of time is considered appropriate (ISO 124 specifies heating until the loss in mass of a 2 g test portion following successive periods of heating is less than 0,5 mg). NOTE 3 In-house methods for determining non-volatile matter often include drying with infrared or microwave radiation. Standardization of such methods is not possible, since they are not generally applicable. Several polymer compositions tend to decompose during such treatment and therefore give incorrect results.
*
*
*
PDF
64,44 € koos KM-ga
Paber
64,44 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

ISO 3451-1:2019

Plastics -- Determination of ash -- Part 1: General methods
Uusim versioon Kehtiv alates 06.02.2019