Tagasi

ISO 6133:2015

Rubber and plastics -- Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strength

Üldinfo
Kehtiv alates 13.08.2015
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
13.08.2015
Põhitekst
Põhitekst
ISO 6133:2015 specifies five methods of calculating, after testing, the tear strength and the adhesion strength of vulcanized rubber or fabrics coated with or adhered to rubber or plastics. The results are calculated by determining the median and range of peak values from a graphical plot of force versus time recorded during the test. A trace for an adhesion strength test or tear strength test can show few or many force peaks, depending on the material under investigation. The choice of the method of calculation depends on the number of peaks in the trace. The purpose of this International Standard is to obtain more uniformity in the evaluation and presentation of test results. It is applicable only, however, when specified in another International Standard, i.e. a method of test or a specification. For other details, such as apparatus, test piece preparation, conditioning, procedure, etc., requirements given in the relevant International Standard shall apply. NOTE In certain cases, the methods of analysis given might not be adequate, for example, for peak values showing a trend with time. In cases where the minimum force values are of interest, it is possible to use the same methods of calculation as when determining from a range of peak values.
*
*
*
PDF
42,23 € koos KM-ga
Paber
42,23 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

ISO 23529:2016

Rubber -- General procedures for preparing and conditioning test pieces for physical test methods
Uusim versioon Kehtiv alates 27.10.2016