Tagasi

ISO/IEC TR 29158:2011

Information technology -- Automatic identification and data capture techniques -- Direct Part Mark (DPM) Quality Guideline

Üldinfo
Kehtetu alates 14.12.2020
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
14.12.2020
Põhitekst
06.10.2011
Põhitekst
ISO/IEC TR 29158:2011 is an engineering document intended for verifier manufacturers and application specification developers. It describes modifications which are to be considered in conjunction with the symbol quality methodology defined in ISO/IEC 15415 and a symbology specification. It defines alternative illumination conditions, some new terms and parameters, modifications to the measurement and grading of certain parameters, and the reporting of the grading results. ISO/IEC TR 29158:2011 was developed to assess the symbol quality of direct marked parts, where the mark is applied directly to the surface of the item and the reading device is a two-dimensional imager. When application specifications allow, this method may also be applied to symbols produced by other methods. This is appropriate when direct part marked (DPM) symbols and non-DPM symbols are being scanned in the same scanning environment. The symbol grade is reported as a DPM grade rather than as an ISO/IEC 15415 grade.
*
*
*
PDF
64,44 € koos KM-ga
Paber
64,44 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

ISO/IEC 15415:2011

Information technology -- Automatic identification and data capture techniques -- Bar code symbol print quality test specification -- Two-dimensional symbols
Uusim versioon Kehtiv alates 15.12.2011
Põhitekst

EVS-EN ISO/IEC 15416:2002

Information technology - Automatic identification and data capture techniques - Bar code print quality test specification - Linear symbols
Uusim versioon Kehtiv alates 01.07.2002