Skip to main content
Tagasi

CLC/TS 50238-2:2015

Railway applications - Compatibility between rolling stock and train detection systems - Part 2: Compatibility with track circuits

Üldinfo

Kehtetu alates 16.07.2020
Alusdokumendid
CLC/TS 50238-2:2015
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
16.07.2020
Põhitekst
05.09.2016
Parandus
08.06.2015
Põhitekst
05.04.2011
Parandus
CLC/TS 50238-2:2010/AC:2011
04.10.2010
Põhitekst
CLC/TS 50238-2:2010
This Technical Specification defines, for the purpose of ensuring compatibility between rolling stock and track circuits the limits for interference current emissions from rolling stock. The measurement and evaluation methods for verifying conformity of rolling stock to these limits in presented in a dedicated annex. The interference limits are only applicable to interoperable rolling stock which is intended to run on lines exclusively equipped with preferred track circuit listed in this Technical Specification. National Notified Technical Rules are still to be used in all cases, where the line over which the rolling stock is intended to run is equipped with any type of older version or non-preferred track circuits that are not listed in this Technical Specification. However, the rolling stock test methodology (infrastructure conditions, test configurations, operational conditions, etc.) presented in this Technical Specification is also applicable to establish compatibility with non-preferred track circuits. This Technical Specification gives guidance on the derivation of interference current limits specified for rolling stock and defines measurement methods and evaluation criteria in a dedicated annex. This Technical Specification defines: a)  a set of interference current limits for RST (Rolling Stock) applicable for each of the following types of traction system: 1)  DC (750 V, 1,5 kV and 3 kV); 2)  16,7 Hz AC; 3)  50 Hz AC; b)  methodology for the demonstration of compatibility between rolling stock and track circuits; c)  measurement method to verify interference current limits and evaluation criteria. NOTE 1  The basic parameters of track circuits associated with the interference current limits for RST are not in the scope of this Technical Specification. NOTE 2  Any phenomena linked to traction power supply and associated protection (over voltage, short-circuit current, under- and over-voltage if regenerative brakes are used) is part of the track circuit design and outside the scope of this Technical Specification.

Nõutud väljad on tähistatud *

*
*
*
PDF
26,84 € koos KM-ga
Paber
26,84 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

CLC/TS 50238-3:2019

Railway applications - Compatibility between rolling stock and train detection systems - Part 3: Compatibility with axle counters
Kehtetu alates 01.02.2022
Põhitekst

EVS-EN 50126-1:2017

Raudteealased rakendused. Töökindluse, kasutatavuse, hooldatavuse ja ohutuse (RAMS) määratlemine ning esitlemine. Osa 1: Põhinõuded ja üldprotseduur
Uusim versioon Kehtiv alates 01.11.2017
Põhitekst

EVS-EN 50126-2:2017

Raudteealased rakendused. Töökindluse, kasutatavuse, hooldatavuse ja ohutuse (RAMS) määratlemine ning esitlemine. Osa 2: Süsteemide ohutuslik lähenemisviis
Uusim versioon Kehtiv alates 01.11.2017
Põhitekst

EVS-EN 50238-1:2019

Raudteealased rakendused. Veeremi ja rongituvastussüsteemide vaheline ühilduvus. Osa 1: Üldosa
Uusim versioon Kehtiv alates 01.11.2019