Tagasi

ISO 12130-1:2021

Plain bearings — Hydrodynamic plain tilting pad thrust bearings under steady-state conditions — Part 1: Calculation of tilting pad thrust bearings

Üldinfo
Kehtiv alates 14.04.2021
Tegevusala (ICS grupid)
21.100.10 Liugelaagrid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
14.04.2021
Põhitekst
15.11.2001
Põhitekst
This document specifies a calculation method for oil-lubricated hydrodynamic plain bearings with complete separation of the thrust collar and tilting pad thrust bearing surfaces by a film of lubricant. This document applies to plain thrust bearings with tilting-type sliding blocks (tilting pads), where a wedge-shaped lubrication clearance gap is automatically formed during operation. The ratio of width to length of one pad can be varied in the range B/L = 0,5 to 2. This document is not applicable to heavily loaded tilting pad thrust bearings. NOTE  Equivalent calculation procedures exist that enable operating conditions to be estimated and checked against acceptable conditions. The use of them is equally admissible.
*
*
*
PDF
131,11 € koos KM-ga
Paber
131,11 € koos KM-ga
Standardi monitooring