Back

EVS-EN 1253-6:2022

Gullies for buildings - Part 6: Trapped floor gullies with a depth of water seal less than 50 mm

General information
Valid from 15.11.2022
Base Documents
EN 1253-6:2022
Directives or regulations
None

Standard history

Status
Date
Type
Name
15.11.2022
Main
This document classifies floor gullies for domestic waste water for use inside buildings, gives guidance for places of installation and specifies requirements for the construction, design, performance and marking of factory made gullies for buildings, irrespective of the material, for use in drainage systems requiring a trap with a depth of water seal less than 50 mm (referred to as floor gullies).
NOTE  Floor gullies with a depth of water seal less than 50 mm are not covered by EN 1253 1, EN 1253 7 and EN 1253 8.
These products are intended to be installed where the three following conditions are met:
-  space limitation will not accommodate a gully with a 50 mm water seal;
-  the building does not exceed a ground-floor and three floors above;
-  at least two domestic sanitary appliances are installed in addition to the gully but with only one WC on the same branch (connection pipe) or secondary or branch ventilation is installed (see EN 12056 2:2000, 4.3.2 or 4.3.4.
*
*
*
PDF
20.40 € incl tax
Paper
20.40 € incl tax
Browse a standard: 2.40 € incl tax
Standard monitoring

Customers who bought this item also bought

Main

EVS-EN 1253-2:2004

Gullies for buildings - Part 2: Test methods
Newest version Valid from 13.05.2004
Main

EVS-EN 1253-1:2015

Gullies for buildings - Part 1: Trapped floor gullies with a depth water seal of at least 50 mm
Newest version Valid from 04.02.2015
Main

EVS-EN 1253-2:2015

Gullies for buildings - Part 2: Roof drains and floor gullies without trap
Newest version Valid from 04.02.2015
Main

EVS-EN 1253-4:2016

Gullies for buildings - Part 4: Access covers
Newest version Valid from 01.06.2016